If your dryer’s not drying clothes or it’s taking longer than usual, you could have a build-up of lint in the lint trap door. Here’s how to clean your dryer lint trap.
When we purchased our home in July it came with a used washer and clothes dryer. We were thrilled because that was one less appliance we needed to buy.
After running several loads of laundry our excitement turned into disappointment. The dryer would dry the clothes but it took at least two cycles to get the clothes dry.
Here it is, a year and a half later and we are still dealing with the same dryer and taking FOREVER to get a load done. We have threatened about a dozen times to buy a new one but it still kinda worked so we kept putting it off.
Earlier this week I took the time and cleaned the dryer lint trap and oh my goodness it has made a world of difference. In fact, I had a load that was completely dry and hot BEFORE the timer beeped!
I am hoping that by sharing how simple this is, you will take the time to clean your dryer vent and see what a difference it makes. The whole thing seriously took less than 30 minutes. I’m embarrassed it took me so long to do it.
How often should you clean a dryer lint trap?
You should remove the lint off the trap before every load of clothes.
As for the deep clean where you clean the trap itself and the slot it goes into, at least once a year.
Supplies You’ll Need to Create this Project:
This post contains affiliate links.
Cleaning the Dryer Lint Screen:
Here is my lint trap. You can judge me by how gross it is because it is bad. And this is when it’s “clean” and the lint has been removed. EWWW!
I immediately brought it to my sink for a good rinsing.
When I turned the water on it wouldn’t even go through the mesh. Airflow is supposed to come through this filter, and if water can’t get through then that makes sense as to why hot air wasn’t making it through.
My tool of choice to clean the trap is a toothbrush. Mine is a freebie that we got from our dentist.
The bristles of the cleaning brush work great at removing all of the little pieces of yucky inside the mesh. Also, use a little bit of dish soap. The dish soap will help remove any residue from the dryer sheets or fabric softener.
I kind of expected that I would have to scrub, but that really wasn’t the case. The yuckies brushed away very easily. I cleaned the lint trap in about 10 minutes.
The lint trap will need to dry before you use it again, but it doesn’t take long to dry at all.
Oh my gosh, you can see through it!
Cleaning the Dryer Lint Trap Slot:
The next step is to get all of the lint out of the lint trap slot. It was hard to get a good picture of the inside but there was lint buildup all over the sides and probably a couple inches on the bottom of that thin little slot.
That is definitely a fire hazard.
The Lint Lizard is a cleaning kit that has an accessory that goes over the end of the vacuum hose attachment that turns into a smaller hose that will fit inside the lint trap slot.
We have a Shark Lift-Away and I love this vacuum.
I inserted the smaller hose into the lint trap and moved it around until I got all of the lint out. This tool is so much easier than using bent hangers to try to remove all of that excess lint.
When I was all done you could actually see the metal of the lint trap. It made me realize how gross it really was!
Cleaning my lint trap really has made such a difference in how well my dryer works, and I am sure it has increased its efficiency by about a billion percent.
How long has it been since you cleaned your dryer lint trap? If it has been more than 1 year I challenge you to get out the old toothbrush and dish soap and get it done.
When you clean your dryer lint trap, please share a photo! We’d love to see it.
